Common solutions for: Does My Whirlpool Washer Need A Diagnostic?

New Whirlpool washers all contain a computerised timer and this is responsible for controlling all the different circuits in the machine, such as the drain circuit and the heating circuit. It gets obvious when your washer experiences hardships as the appliance communicates with the help of special codes. They appear on the screen and can be found in the manual guide. If you suspect that there’s a fault in one of the circuits in your machine, it’s usually much easier to test all the components in the circuit then trying to prove that the problem lies in the control board. For example, in the drain circuit, you would check the drain pump and the wiring, while for the heating circuit you would check the element, the thermostat and the wiring. If you then suspect that the problem still lies in the circuit board, unfortunately, it’s usually quite difficult to test the board and you’ll actually just need to replace it altogether. If your machine is tripping the electricity, the process for diagnosing is largely the same - however, it may be that a normal meter won’t show any fault being present. In such a scenario an engineer would use an insulation tester such as a Megger, and this produces 500 volts for determining where the breakdown has occurred. Again, it’s likely to be due to the heater or heaters if it’s a washer-dryer appliance, but if the tripping is occurring during the final spin then it is the motor that is likely to be at fault - as this is where it’s being worked at its hardest during that part of the cycle. You can try to diagnose the problem you are experiencing with your washing machine. In fact, professional assistance will save your time and efforts being more beneficial. No matter what variant you prefer, maintenance your unit regularly!