If the times on your GE Monogram JGB700SEJSS stop working - one of the most common solutions for this trouble would be to replace the control board. Follow our simple step-by-step guide to replace the control board. Our guide is very simple. You need to prepare some tools before starting: nut driver set or wrench set, screwdriver, putty knife, work gloves, cardboard to protect flooring. Let’s begin!
Set cardboard on the floor in front of the range to prevent scratching the floor. Pull the range out of the cabinet and unplug the power cord and shut off the gas supply. Use a helper if necessary. Remove the screws from the control panel back shield and pull it off the range. Take a digital picture of the wires attached to the control board to document their locations so you can attach the wires to the new oven control board the same way. Disconnect all the wires from the oven control board. Remove the mounting screws and pull the oven control board out of the control panel. If the overlay on your existing oven control board is in good shape and you’re going to use it on the new oven control board, carefully pry off the existing overlay using a putty knife. Enough adhesive residue will remain on the back of the overlay so you can attach the overlay to the new oven control board. Transfer the overlay from the existing control board. If you bought a new overlay for the control board, attach the new overlay to the control board. Position the electronic oven control board and reinstall the mounting screws. Carefully connect all the wires to the new oven control board using your digital image as a reference. Place the control panel back shield on the back of the control console and secure the back shield with the mounting screws. Plug the power cord into the electrical outlet and turn on the gas supply. Carefully slide the range back into the cabinet, ensuring that the rear leveling foot properly engages with the anti-tip bracket so the range doesn’t fall forward when you open the oven door and pull out a loaded oven rack. Use a helper if necessary.
Done! Now you can set a timer. Make some tests! Feel difficulties during replacing the control board? You can contact our customer support team and arrange an appointment at the convenient time.
