Your washer gives problems with running? Read our article. We are here to help you. In case that washer Electrolux eifls60lt1 isnìt running - damaged or broken user interface board. We have step-by step on how to easily change the interface board at home. First of all prepare some tools: slot screwdriver,Phillips screwdriver, work gloves.
- Shutting electricity. Unplug your washer. Use working gloves. Move the washer away from the wall.
- Removing top panel from the washer. Remove the 2 screws on the back of the washer that hold the top panel. Pull the top panel toward the rear of the washer and lift it up and off.
- Removing the screw on the back of the control panel. Using a Phillips screwdriver, remove the screw on the back of the control panel. The screw is on the right side as you face the front of the washer.
- Removing the screws in the dispenser drawer housing. Pull the dispenser drawer forward until it stops. Release the locking tab at the back of the dispenser drawer and then pull it completely out of the dispenser housing. Using a Phillips screwdriver, remove the screws on each side of the dispenser housing.
- Removing the control panel. Unplug the wire harness connections for the control panel by pressing on the release tabs and sliding the connectors apart. Stand in front of the washer and lift up on the control panel to release the top. Pull the control panel off the washer.
- Removing the user interface board. Remove the screws that secure the user interface board in the control panel.
- Installing the new user interface board. Place the new interface control boards into the control panel and install the screws loosely. Make sure that all the buttons are lined and can depress the switches on the interface board when you push the buttons. Carefully tighten the mounting screws.
- Reinstalling the control panel. Position the control panel on the top of the front panel. Reinstall the screws in the dispenser housing. Reinstall the screw on the back right side of the control panel. Plug in the wire harness connections for the control panel. Push the detergent dispenser back into the drawer housing.
- Reinstalling the top panel. Push the panel down and forward to seat it on the washer frame. Reinstall the screws to secure the back panel. Avoid overtightening.
- Plug your washer in the outlet. Return the washing machine back to position and make some tests.
If this doesn't work, there could be a defective part that requires a replacement, and you may need to consult a professional.
