Have no doubt your Whirlpool microwave is going through the hard times if it isn’t heating anymore. Fortunately, that is a typical breakdown the technicinal is able to fix easily. Before checking main parts of your appliance for a failure check the controls, power error or display codes and make sure the interior has been cleaned. Then, move on to the diode. The diode converts the A/C power output of the transformer to D/C, doubling the voltage to nearly 5,000 volts. This high voltage powers the magnetron to heat the food. If the diode burns out, the magnetron won’t receive enough voltage to operate, preventing the microwave from heating. When the diode fails, it is often visibly burned out. Inspect the diode and if the diode is burned out, replace it. If inspecting the diode proves inconclusive, test it with a multimeter that uses a 9-volt battery or put a 9-volt battery in series with the diode. When the leads are reversed, the diode should only have continuity in one direction. The door switch might cause issues being defective. Most microwaves have three or four door switches. When the microwave door closes, the door switches actuate in sequence to ensure that the door is closed properly. If any of the door switches fails, the microwave will not start or heat. To determine if any of the door switches are defective, use a multimeter to test each of the switches for continuity. If any of the door switches does not have continuity, replace it. Don’t hesitate to advert a professional helper to get high quality maintenance and cleaning. Remember to check your Whirlpool microwave every six months for normal function and clean it regularly.
November 26, 2023
AC is leaking from the coil – HVAC Troubleshooting in San Diego
Have you encountered a leaking air conditioner? This causes not the most pleasant feelings and deprives you of comfort. Before solving this problem, you should determine what exactly became the source of the air conditioner flow.
